High Lifter Snorkel Kit Polaris Ranger XP 900 / Crew 2013-2016 [Incomplete]

Item Condition: This item is missing: (1) 1/4" Flat washers

High Lifter Snorkel Kit Polaris Ranger XP 900 / Crew

High Lifter Snorkel Kits are the highest quality, most comprehensive snorkel kits in the side by side and ATV industry. High Lifter Kits are designed for peak performance while maintaining OEM-levels of fit, finish and appearance. Air intake routing uses a combination of HD vinyl tubing and high temperature silicon hose. High Lifter kits use a system of bellows to protect differential, transmission, clutch housing and other vented components from water intrusion, as well. In DIY or sub-par aftermarket snorkel systems, heat and vibration are the most common causes of snorkel failure. High Lifter Kits are engineered for long-term resistance to leaks, extreme temperature and vibration failure with quality, thick-walled materials and rubber-mounted intake bracketry.

 A snorkel kit is intended to provide clean, dry air to the engine and other parts needing venting on ATVs and UTVs such as clutches, differentials, transmission, carburetors and fuel tanks. High Lifter Snorkel Systems do not necessarily mean the ATV/UTV should exceed the OE manufacturer’s stated maximum rated water line depth. Snorkel Kits are intended as an additional margin of protection in the event that the machine is inadvertently driven into water deeper than the OE manufacturer’s air intakes will tolerate. There are many considerations to make when increasing water line depth, and High Lifter Snorkel Kits are just one component.

Features:

• Provides clean, dry air to the engine and other parts needing venting
• Prevents mud, water and debris from entering the engine and clutch housings (when equipped)
• Bellows allow the differential and transmission air to expand and contract without the need for long vent lines that can easily get plugged with mud or be pulled off
• Each Kit is engineered and cut to fit your specific application
• Kit includes all hardware needed to properly snorkel your ride
• Custom powder coated riser bracket to keep risers straight, evenly spaced and looking good
• Rubber mounted snorkel routing brackets to dampen vibration
• Heavy-duty, thick-walled vinyl intake tubing
• High heat silicone hose used in critical areas
• Bellows to keep water out of differentials and transmission
• Step-by-step instructions complete with detailed photos
• Additional Ultra Black silicone sealant, medium silicone and dielectric grease are optional but recommended for installation and future preventive maintenance

Note:  Cutting / trimming some body plastics is required to install this kit. When installing the snorkel kit, you are altering the airflow to the carburetor / throttle body and a jet kit or EFI programmer may or may not be required once the kit is installed.