Woodcraft 10mm Swingarm Spool Sliders
Good fit for Ninja 650
You will need you use the included spacers to clear swing arm on Ninja 650.
I ordered stepped 10mm
You will need 8mm hex bit to install.
Don't forget you locktite!
Will update after using stand.
April 2, 2016
Nice product but..
Ok this is a very nice spool.. I know it wasn't for my sv but bought it anyway.. Just needed to change the bolt.. But other than that it looks amazing..
February 9, 2016
The only reason I didn't give this product a 5 star rating was solely due to lack of instructions. I'm a handy person and the install was simple, but I still think a short set of directions would have been nice. I even checked Woodcraft's website and there were no directions there either.
I watched a couple of YouTube videos which suggested using a thread locking compound. Maybe it's not necessary, but it sounded like a good idea...like something you might want to mention in set of directions!
Other than that, the construction of the spools and the mounting hardware seem very well made. I'm using this with a Pitbull forward handled stand with no problems at all.
November 23, 2015
These slider spools are great! Easy to install and very useful for lifting the bike. I can personally attest to their crash protection as well. I had a low side at the track and my swing arm and entire rear of the bike didn't get so much as a scratch.
June 17, 2015
Great Sliders for the money
Purchased these for my Ninja 650 as couldnt find much else to fit without a spacer. Bolted right up, look good, and work with my stand. Thanks!
March 26, 2015
Easy to install
I got these for my Ninja 300. They're super easy to install and not only do they serve as swingarm spools but they protect the swingarm if the bike tips over. Fast shipping from Revzilla!
February 19, 2015
Useful spools that will protect your swing!
These are simply rear stand spools that double as sliders. I believe they are made of the same plastic that the Woodcraft slider pucks are made from. I think it is delrin. They have a stainless bolt inserted and came with spacers to clear the swing arm on my ZX-10R. They seem very sturdy. They work great with my rear stand and seem like they would offer protection in a crash.
One point I would like to make is that these are very large. If you are looking for spools that are understated and would go unnoticed, these are probably not the ones for you.
December 12, 2014
Great product, great service.
I needed a way to do some maintenance on my 2013 kawasaki Versys and so I bought these. Easily installed. I'm going to use some locktite to make sure they don't vibrate out. Thanks again, Revilla!
December 9, 2014