Yoshimura R-77D Slip-On Exhaust Honda CB1000R 2011-2015
Great sound, easy to install
Yoshimura makes the best exhaust, with great sound and easy to install. Great finish and looks good on bike
July 21, 2014
I mean its a Yosh....
What else can you say? It's light, beautiful and mean as can be.
Small noticeable difference in the mid range. Big difference in the tone! Love it.
The only downside is, and maybe I'm missing it but, there's no heat shield on the right side so my right foot gets cooked.
July 21, 2014
As always Yoshi delivers the best sound and performance
As you may expect from Yoshimura products this one doesnt dissapoint when it comes to built quality. Everything fits just like it supposed to, you just have to tweek the pipes a bit because they ran awefully close to the rear wheel. Otehr than that ut fits great and saunds awesome.
May 27, 2014
You don't know what you are missing
I loved the stock exhaust look and sound. Until I heard the Yoshi in person. It is beautiful and I think it is about 10 lb lighter than the stock one. The difference can be felt but I look forward to do more riding to get more feel of it. The throaty sound is def great over the stock one. this it eh 4/3 system and the exhaust clip is redesigned on this to give the bike more ground clearance but with another winter storm on the way, I have not had a chance to find out (or not find out if I could scrap it). The only thing is no picture to show how much clearance there should be between the muffler to the rear tire and it is pretty close. The installation is pretty straightforward just need a bit more force to take the stock off the header and to push the yoshi into the header. leaving blank on the durability since I dont know. I took 1 off the ease of install because the instruction says to remove the header bolt and let it swing down but it is easier to remove the rear tire to give you the room to remove the stock one.
March 3, 2014
Easy to install and excellent sound
There are only a few products out there that are designed for the CB1000R. This happens to be the best looking one and keeps the clean look of the single side swing arm while reducing dramatic weight off the stock system and increasing performance and sound quality. I approve. :)
July 15, 2013
Great looks and sound!
This is the updated version that doesn't have the ground clearance issue the original design had. Exhaust is super light compared to the factory setup.
The instructions say to loosen the header nuts and swing the exhaust down. They say that because the cat is trapped by the rear tire and a clamp that hits the frame. I found it easier to remove the rear wheel and rotate the clamp out of the way, slides right off. You don't use any of the OEM gaskets, so don't panic if they tear.
Looks great with the Cynos matte black. I'm loving it!
June 27, 2013
Great rumble, easy install
Super easy Install on my '11 CB1000R, snug solid fit, sounds great with a low throaty rumble at idle, looks sick, and a noticeable increase in acceleration "snap". Overall I'm very happy with the purchase (durability not rated as its only been installed a week)
April 15, 2013