Yoshimura Fender Eliminator Kit Kawasaki Ninja 300 2013
Very easy to install and looks great!
I did a lot of research on kits to buy and chose this one and I'm glad I did. It was pretty easy to install and it looks great. It really cleans up the bike.
April 19, 2014
Looks great. Don't expect to get anything out of the instructions. Pretty easy though. Overall I'm in love with the look it gave my 300
April 9, 2014
Cleans the rear end up!
As with all the other reviews you will see, the only thing on installation is that you reall need to run the license plate light through the mounting bracket before you crimp the wires. I did this, then of course when I tried to put everything together I had to cut wires and re-crimp again. Stock turn signals were kinda of a pain to re-install on the bracket but went in there tight like it should. TAKE YOUR TIME DOING THE INSTALLATION! In the end it is well worth it!
April 8, 2014
Great looking fender eliminator
This fender eliminator really cleans up the rear end of my Ninja 300. And it has a very nice, almost OEM, look to it since it uses the original turn indicators. The installation really wasn't that difficult, but the removal of the stock indicators and fender was a little harder than anticipated due to the angle which you have to access the screws. But, other than that, the install was straight forward. It would be nice if it included an extra electrical connector in case you mess up one of the two provided.
April 8, 2014
Sleak look easy to install
I've never done any mod work before, but the instructions were easy to understand. Once I had all the right tools (heat gun) everything kind of fell into place. Love the look so much better than the stock fender and especially like that it uses the stock turn signals.
April 7, 2014
Directions are lacking.
The installation directions are complete, but they are not thorough. Just be sure to crimp the wires as the last step before you put your back seat back on. There is no need to do it any sooner, and you avoid having to re-cut your wires and use wire-nuts until you buy new butt splice connectors.
March 3, 2014
Looks great and retains factory signals
I bought this cause it uses factory signals and looks it took me about an hour only cause I chose to solder led license plate light seems to be well built and looks good
March 3, 2014
Very unclear instructions.
Installation wasn't a pain, just the instructions were. It's a great product. You need to remove all stock parts of the original fender. And instead of cutting the turn signal wires I cut into the fender, I had no more use for it. A friend suggested to just tuck away any excess wiring and only cut the licence plate light.
No need for extreme cutting and have extreme patience. I suggest installing the bracket frame first with the license plate light and then work around installing the turn signals.
Follow the diagram and possibly review some videos/forums who have previously done so.
December 28, 2013