Yoshimura Fender Eliminator Kit
Should be the stock fender
I realize that Bike manufacturers have to have everything DOT approved, but the stock fender is so ugly on most bikes. This should be the stock fender.
Installation is very straightforward, however, there were no instructions on how to wire it properly. With some common sense and googling it is fairly simple to figure out, but I still ended up having to take it a professional to rewire it after I attempted and failed. I was able to get one blinker working and the license plate light, but for the life of me could not get the second blinker to work.
Regardless of having to spend another $80 to have someone fix my work, I still give this 5 stars and would recommend it to anyone. Most of the other eliminators have illegal license plate placement and will get you pulled over where I live. This looks great and also has a very visible plate placement.
April 24, 2014
Very easy to install and looks great!
I did a lot of research on kits to buy and chose this one and I'm glad I did. It was pretty easy to install and it looks great. It really cleans up the bike.
April 19, 2014
1) Love the look
2) Instructions weren't the best but they got the job done
3) Looks fantastic
4) Looks pimptastic
April 12, 2014
Looks great. Don't expect to get anything out of the instructions. Pretty easy though. Overall I'm in love with the look it gave my 300
April 9, 2014
Cleans the rear end up!
As with all the other reviews you will see, the only thing on installation is that you reall need to run the license plate light through the mounting bracket before you crimp the wires. I did this, then of course when I tried to put everything together I had to cut wires and re-crimp again. Stock turn signals were kinda of a pain to re-install on the bracket but went in there tight like it should. TAKE YOUR TIME DOING THE INSTALLATION! In the end it is well worth it!
April 8, 2014
Great looking fender eliminator
This fender eliminator really cleans up the rear end of my Ninja 300. And it has a very nice, almost OEM, look to it since it uses the original turn indicators. The installation really wasn't that difficult, but the removal of the stock indicators and fender was a little harder than anticipated due to the angle which you have to access the screws. But, other than that, the install was straight forward. It would be nice if it included an extra electrical connector in case you mess up one of the two provided.
April 8, 2014
Sleak look easy to install
I've never done any mod work before, but the instructions were easy to understand. Once I had all the right tools (heat gun) everything kind of fell into place. Love the look so much better than the stock fender and especially like that it uses the stock turn signals.
April 7, 2014
Great looks and easy installation
The Yoshi tail tidy works great. Gives a very clean look with an easy installation guide. I combined mine with a new brake light that has the turn signals integrated, so it looks really clean without the turn signal stalks.
It's held up well so far, no issues at all.
March 31, 2014