Symtec Heat Demon Heated Grip Kit
Product Rating:
4.4 / 5
- 5 Customer Reviews
- Review this product for a chance to win a $100 gift card.
- Add to My Wish List
- Email this to a Friend
Customers who viewed this product also viewed these items:
Symtec Heat Demon Grip Warmers
$116.95
Hot Grips Heated Hand Grips
$79.95
Gerbing's Heated Glove Liner
$89.95
Heat Demon Heated Grip Kit
- Complete motorcycle hand warmer kit with high and low heat settings
- Fits under existing grips of most motorcycles
- Comes with metal toggle switch
- Current draw is 20 watts on low setting and 40 watts on high setting
Heat Demon Heated Grip Kit with Metal Switch
5
5
Good instructions.
Put these on my wife's Bonny. The instructions were pretty easy to follow. The wiring was a little tricky because the switch needs a lot of space behind it to accommodate the connectors. Once on, they heat up nicely..
May 6, 2013
Laborious Install, Great results
If you have a period of time to completely dismantle your bike enough to perform a really clean install of this product, like say winter, then this is a great product. The install was almost more than I could chew and required the purchase of an aftermarket rocker switch so that it looked stocked, but let me tell you... there are few things in life as sweet as warm hands when riding a bike in cold weather, and this product definitely delivers on that.
May 4, 2013
Hot Grips
Information on Revzilla was complete. The package arrived 2 days ahead of the expected delivery. Instructions were clear about fitting and wiring. Installation was accomplished by following the steps, getting the grips off is always a challenge even with an upgraded air compressor. The grips are nice and toasty for the morning commute. I installed the grips as a back-up to heated gloves, one failed on a trip, since has been replaced by the manufacturer. Warm hands are definitely are better for safety. With these heated grips you don't have to stop to change to heavier gloves the day cools off on a day trip. The high setting is good the get the grips up to temperature and then the lower setting works for keeping maintaining. I would recommend these. A word of advice, before you buy take the grips off and see if you have a knurled surface on the bars, be prepared to grind this down, otherwise it's a piece of cake.
November 27, 2012
GREAT HEATED GRIPS!
VERY WELL BUILT AND DESIGNED. KEEP MY HANDS NICE AND TOASTY NOW THAT ITS GETTING COLD AT NIGHT.
November 5, 2012
Best Grip Warmers Out There
These grip warmers are great. They do not use a resistor so when on the low setting they save your electrical system valuable power. These are a must for cold weather riding.
October 8, 2012
1-5 of 5
Have a functionality, fit, or otherwise product-specific question about the Symtec Heat Demon Heated Grip Kit? Ask it here! If you have a customer service or shipping question, please direct it to our Customer Service department.
(3 Questions : 5 Answers)
Product Q&A
Ask your questions. Share your answers.
All
All
Heat Demon Heated Grip Kit with Metal Switch
1 answer
Does anyone know if these will fit an '05 V-Strom (DL650)?
by
State: IL
Rider Type: Commuter
Age: 35-44
Gender: male
Antioch
Additional information about Weasel could not be loaded.
2005 DL650 - would love to install a product like this, but don't know if it will fit, as it clearly states "fits MOST..."
State: IL
Rider Type: Commuter
Age: 35-44
Gender: male
2 months, 1 week ago
by
State: IL
Rider Type: Commuter
Age: 35-44
Gender: male
Antioch
Additional information about Weasel could not be loaded.
1 FollowerI have this question too
Answers
Answer:
The heated grips will install on any motorcycle that has round handlebars and where you have an ACC wire that you can tap into for power, i.e., a headlight. You would be fine with a V-strom and getting this product.2 weeks ago
Has staff answer
Heat Demon Heated Grip Kit with Metal Switch
2 answers
I have a 2012 Triumph Tiger 800 roadie, are these warmers a fit?
by
State: AZ
Rider Type: Moto Enthusiast
Age: 55-64
Gender: male
Gilbert
Additional information about tiger2012 could not be loaded.
State: AZ
Rider Type: Moto Enthusiast
Age: 55-64
Gender: male
6 months ago
by
State: AZ
Rider Type: Moto Enthusiast
Age: 55-64
Gender: male
Gilbert
Additional information about tiger2012 could not be loaded.
1 FollowerI have this question too
Answers
Answer:
The Heated Demon will does fit most bikes. However, you may have to cut off your original grips if they are glued on making them unusable once you are ready to install the heating elements. You may want to order a set of replacement grips at the same time so you can speed up the installation process.6 months ago
Answer:
I put these on my FJR1300, the clutch side internal grip diameter is 22mm and 100 mm long. The heat pad wraps round the metal of the handlebar tube, then the grip slides over the top. The heat pad is only about 80mm long and is placed to maximize the heat to the hand. The throttle side is lager and the heat pad fits the same way.Age: 55-64
Gender: male
5 months, 3 weeks ago
by
Age: 55-64
Gender: male
COLUMBIA
Additional information about Peter B. could not be loaded.
Has staff answer
Heat Demon Heated Grip Kit with Metal Switch
2 answers
Who makes these grip heaters?
by
State: NY
Rider Type: Commuter
Age: 25-34
Gender: male
New York, NY
Additional information about J could not be loaded.
What company makes these grip heaters? What is the manufacturer's model number?
State: NY
Rider Type: Commuter
Age: 25-34
Gender: male
1 year, 6 months ago
by
State: NY
Rider Type: Commuter
Age: 25-34
Gender: male
New York, NY
Additional information about J could not be loaded.
1 FollowerI have this question too
Answers
Answer:
To clarify OldManRick's comment, I've linked the plastic rocker switch version below:Age: 25-34
Gender: male
1 year, 6 months ago
by
Age: 25-34
Gender: male
PHILADELPHIA
Additional information about Chris K. could not be loaded.
Answer:
Symtec makes these. Part Number 210019MTSee more at:
http://www.symtec-inc.com/External-Handlebar-Warmer-Kit-Motorcycle-MT_p_24.html
Note the Revzilla photo shows both a metal togel switch and a round rocker switch, but the product description specifically says it comes with a METAL switch, and the part number listed by Revzilla is for the metal togel (MT) switch. Symtec lists these as two separate items (part numbers end in MT or RR).
Since you will probably only need one switch, it might be worthwhile clarifying with Revzilla whether the round rocker (RR) switch is available from them, should you prefer it.
Age: 55-64
Gender: male
1 year, 6 months ago
by
Age: 55-64
Gender: male
Cedar Rapids
Additional information about OldManRick could not be loaded.
1 of 1
1 of 1
| Product Style | RevZilla SKU ID | Manufacturer Product # | Availability |
|---|---|---|---|
| Symtec Heat Demon Heated Grip Kit | 593050 | 210019MT | In Stock: Ships within 24 hours |
