Shogun Bar End Sliders Kawasaki ZX10R 2011-2014
Fit grate on my ZX14r.
The bar ends my bike came with were steel so after about a year all the paint began to bubble up. I bought these and they look very similar to the factory ends just a hair smaller in diameter. The supplyed bolts were the correct length and thread pitch but I decided to use the factory.No particular reason why.
July 16, 2014
Clean Look, Easy to Install
So before I had these bar ends, I had a pair of cheapo ends on from the previous owner - I lowsided at the track recently - Actually in the grassy runoff area and not on the pavement itself luckily, and even in the grass, the bar end just got sucked right off the bike. You get what you pay for. The mounting bolt included with these is like .5 inches longer than stock so I would bet that if I were to repeat my previous performance, these Shoguns would fare better. Clean finish, look great on the bike, and easy install. No complaints.
May 29, 2014
Shogun sliders are some of the best on the market at an affordable price. This is my second set. I had a low side on the track and they performed flawlessly. The mounting bolts did not bend in the crash. The slider material slid smooth on the pavment and did not catch on anything. Highly recommend!!!
May 26, 2014
Easy to install
Replaced the standard metal bar ends with these which are made of a more plastic like material. I'm not sure if they will do anything to protect the handlebars to be honest they just swap out with my standard bar ends. They likely work if a slide but i have not tested them with a crash yet!
March 19, 2014
Very nice but didn't fix my 04 R6.
Great product but did not fit my 2004 R6.
I did get it on with the universal insert
from my old bar end.
Looks amazing! Worth it!
February 12, 2014
Looks amazing on the bike and the price was just right!!
December 31, 2013
Easy install haven't actually had to use them for their purpose but they look good.
November 25, 2013
If you have a 2011-2013 ZX10R this won't fit as they say.
I don't usually do a "bad review" on items, but this really grindz my gears. NOTE...this is only for the Bar ends made for a 2011-13 ZX-10R and I can not speak of any other model.
This flat out doesn't fit. The groove that is milled into the back end is not deep enough to cover the OEM end bolt/nut the bar end screws into. Also the milling is to wide that even if you tighten down the bar end is never center correctly. It sits so high on the bolt/nut that it looks like in a drop or any crash the bar end will snap at the bolt and save nothing.
If you have a ZX-10R...sexy...look else where.
October 2, 2013