Pit Bull 10mm Spool Kit
Fits well on my RC390, does the job well.
Took about 5 minutes to install on my KTM RC390. They include spacers, but I did not install them, as I didn't want them to stick out too far. I can't comment on durability at this point, but they appear that they would hold up well in a low speed slide, and the metal bolt is inset enough that it would take a good amount of sliding before the delrin got ground down to the metal. As expected, they work great to pick the bike up with my rear stand. They don't look goofy or bulky at all.
August 11, 2015
I just installed these last weekend on my 09 Ninja 650R and they worked perfectly. Went right in. No problems whatsoever. Used them with PitBull SS Rear lift and the bike felt super stable.
July 20, 2015
Okay I got it in one day . It fits great looks great and was super easy to do. Like if you can't put them on you shouldn't be riding it's that's easy....
July 14, 2015
Bought for a 2015 ninja 650. The 10mm were recommended. I spent 2 hours trying to slowly walk the bolt in thinking it will thread itself in as there is over spray with the powder coating. One side went in without stripping it but the other instantly stripped the threading.
June 30, 2015
If you own a Ninja 300 look away
I can only speak for the Ninja 300 10MM Spool, and can't say anything else about other bikes and this spool. One easy sentence: Don't waste your time or money on this. Arrived promptly, which was great. But when prepping my work area and i tried screwing in the allen bolt just a little and it felt odd. Called RevZilla and asked them about it and as quoted:"... It may be difficult to install but keep going...". Okay. Simple enough I dapped some loctite onto the bolt and start screwing straight in, not at an angle to miss-thread. Half-way through the bolt stops, and still hasn't touched the other end of the swing arm. Somethings wrong, it won't go forward it won't come out. Great so its stuck and after trying to fully install it I get frustrated and try to remove it. I was using the proper SAE metric allen head key and in the process of trying to remove it the head of the allen bolt on the swingarm spool stripped. After further research PitBull 10MM DON'T FIT A NINJA 300 which was claimed by sales reps and the pdf on this page. In the process of trying to remove this right now, but please don't waste your time or money. Buy a quality swingarm, Pit bull makes great stands, but terrible spools. If you own a 300, look elsewhere.
June 5, 2015
Does the job well, looks good
Got this product for my 2014 Kawasaki Ninja 300. Product looks great and does the job welll. No problems whatsoever with the product in general. Quality also seems to be very nice. I had a problem with the threading on my bike and had to retap the spool sockets and hence installation was not that smooth. But that was a Kawasaki error and nothing to do with the product. The finish did get a few scratches when I had it on the sidewalk and trying to install but not a big issue I think.
Would definitely recommend this product. Overall rating I gave was 4 cause after looking around, I like the looks of the rubberized spools more and feel like they might be easier to work with.
May 31, 2015
8MM are great
Spools look good and are super strong. Work great with the Pit Bull stands.
April 6, 2015
Very nice fit and finish to the hardware. Works well with the PitBull stand I also got from Revzilla. Install was easy with a little lock tight and an allen wrench. I purchased the green set and it was a little darker than the picture shows but other than that a solid spool choice.
April 5, 2015