Log In / Register
Cart (0) Checkout
Dynojet Power Commander V for Victory 106 cu in Models 2009-2014
Zoom
  • Dynojet Power Commander V for Victory 106 cu in Models 2009-2014
Select qty:
MSRP
$369.95
Your Savings (6%):
$22.85
Your Price
$347.10

View more like this:

Video Review

Dynojet Power Commander V for Victory 106 cu in Models 2009-2014 Videos

Dynojet Power Commander V

  • Reduced size from PCIII USB - less than half of the size of Power Commander III
  • USB powered from computer, 9 volt adapter is no longer needed for programming
  • "Warm Up" fuel adjustment reads engine temp and allows fuel/timing adustments based on the reading
  • For use on 2009 and up applications
  • 2 position map switching function built in (map switch not included)
  • Gear/Speed input allows for map adjustment based on gear and speed
  • Analog input allows user to install any 0-5 volt sensor and build an adjustment table based on its input such as boost or temperature
  • With gear position input connected the PCV is capable of allowing each cylinder to be mapped individually and for each gear - for example: on a 4 cylinder bike with a six speed transmission there could be up to 24 separate fuel tables
  • Unit has a -100/+250% fuel change range (up from -100/+100%), this allows more adjustment range for 8 injector sportbikes
  • 10 throttle position columns (up from 9 on PCIII USB)
  • Enhanced “accel pump” utility for increased adjustment and sensitivity ranges
  • Made in the USA

Note: Not legal for sale or use on pollution controlled vehicles.

Resources:

This Product Fits:
Victory
Boardwalk 2013, 2014
Cory Ness Jackpot 2009, 2010, 2011, 2012
Hammer 2009, 2010, 2011
Hammer 8-Ball 2011, 2012, 2013, 2014
Hammer S 2009, 2010, 2011, 2012
Hard-Ball 2012, 2013
High-Ball 2011, 2012, 2013, 2014
Jackpot 2012, 2013, 2014
Judge 2012, 2013, 2014
Kingpin 2010, 2011, 2013
Kingpin 8-Ball 2010, 2011
Vegas 2010, 2011, 2012
Vegas 8-Ball 2011, 2012, 2013, 2014
Vegas Jackpot 2009, 2010, 2011
Write a Product Review for a chance to win our monthly $100 giveaways.
Dynojet Power Commander V for Victory 106 cu in Models 2009-2012 4.7 5 19 19
Power commander with yoshimura RS-5 cbr600rr Works well with y yoshimura full racing exhuast would recommend January 20, 2014
is great easy to install take time to run wiring works really well with auto tune July 1, 2013
Excellent product. This product is a must have if you are going beyond basic modifications. You may not need a programmer for just a pipe and filter but anything more and you will want the ability to add or remove fuel to make your bike run right. Combined with the Auto Tune module and you have the best combination for total control of your fuel delivery and you can let it run automatically and never touch it again or you can get in the details and tweak and tinker as much as you want. There are safety limits but if you don't know what you are doing I would not get to crazy with adjusting. I really love this product. June 24, 2013
PCV Wow, small size but made a big difference on my bmw s1000rr. I put a akra full exhaust shorty and it did not run very good, so I bought this and got it installed. Now my bike is loud, more power every rpm specially at the lower rpm. Could not ask for more. Buy it, you will love it!!! July 15, 2013
The Beemer is a rocket ... I have just had Powerhouse Dyno Tuning at Nerang Qld. here in Australia install the Power Commander V and create a map for my 2010 S1000RR. It is coupled with a BMC air filter and the full Yoshi R-77 Ti Carbon exhaust system also purchased from Revzilla. The end result is 197.83HP at the rear wheel; of cause the numbers can vary from dyno to dyno but the bike and Yoshi system is running much smoother now. You would think it would be hard to improve on the RR standard setup ... but it has. The product as well as the technical advice from the guys here at Revzilla has been excellent ... thanks guys. June 15, 2013
2012 M109R Limited I have installed the Power Commander V after putting on an aftermarket high flow air filter system and drilling the baffles out on the stock exhaust. Was worth it, although I did not put it on a dyno yet, I do get more responsiveness. It came with pre-programmed fuel map and it works flawlessly. Installation was a bit challenging just due to the bike's design and routing the cable avoiding hot spots. My bike looked like something out of a transformer movie during installation, but you do have to get through some tight spots, so the more space you have to maneuver, the easier it will be. You will also most likely have to cut the insulation mesh a bit back just to get a bit more wire from the harness. You will see what I mean once you do the installation and realize that you can't quite reach the connector on the other side. That is without taking the air box off. Try to do it without dismantling it. Overall great product, small fits great looks great, works just great. Get it it's worth it, if anything a piece of mind your engine will work properly. January 14, 2013
easy install and great performance potential i found this product very easy to install with good instructions. i downloaded the map from the dynojet site which gave me a good start but wasnt good enough. the map was only for a stock air filter with full akra evo system. i needed a better map due to an aftermarket airfilter i have. overall the product is great, but tuning on a dyno is a must,to get the perfect map for your bike and the conditions you ride in January 7, 2013
Good Upgrade to anybike Performance I am a fan of PC and had it in my last 3 bikes (all "racing" bikes). It helps making the bike smoother, with a better air & gas mixture and no "holes" in the engine & gear relation. Its very good if you want to use your bike for track days or so, once you can change the configuration very easily and adapt it to what you want to get. I like and recommend it. December 31, 2012
2 3 next>>
Use our Product Q&A for a chance to win our monthly $100 giveaways.

Have a functionality, fit, or otherwise product-specific question about the Dynojet Power Commander V for Victory 106 cu in Models 2009-2014? Ask it here! If you have a customer service or shipping question, please direct it to our Customer Service department.

Dynojet Power Commander V for Victory 106 cu in Models 2009-2014
Already Asked: 5 Questions, 4 Answers
Sort by:
A shopper asked: I'm a little confused on adding maps. Does the Power Commander have the ability for me to search for maps on my laptop, find one that is suitable, then load it into my Victory or do I have to get it dynoed? Sep 16, 2012
Answer this · Send to friends Good question? Yes (0) No (0)
RevZilla: Mapping is in reference to fuel maps. It come preprogrammed with the correct map. However the unit does allow for the map to be modified if you want to change it. We do not recommend making changes unless done by a professional tuner on a Dyno. Maps downloaded from forums or unreliable sources can have catastrophic consequences if you do not know what you are doing. Sep 18, 2012
Reply to RevZilla Good answer? Yes (0) No (0)
Product Style RevZilla SKU ID Manufacturer Product # Availability
Dynojet Power Commander V for Victory 106 cu in Models 2009-2014 598358 19-002 In Stock: Ships within 24 hours